Envirolite Easy-UP EV40543BMJ Instrucciones De Instalación

Luminaria empotrable led 4”

Publicidad

Idiomas disponibles

Idiomas disponibles

Enlaces rápidos

Please read carefully and save these instructions,
as you may need them at a later date.
GENERAL: All electrical connections must be in accordance with local and
National Electrical Code (N.E.C.) standards.
instructions and review the diagrams thoroughly before beginning. If you are
unfamiliar with proper electrical wiring connections obtain the services of a
qualified electrician.
BEFORE YOU BEGIN
1.
Check if the power source is suitable for the added electrical load.
Power should be supplied by a 110/120 volt, 60 Hz single circuit. The
rated wattage is marked on this product. When installing multiple lights
on a branch circuit, follow NEC guidelines to determine the maximum
number of allowable lights (1400 Watts for a 120 Volt, 15 Ampere
circuit). If a dimmer is used, do not exceed its rated wattage limit.
2.
This fixture is an IC type fixture. It may come in direct contact and
be completely covered with thermal insulation that has an R-value
of 50 or less. Some insulation types that meet this requirement
are blanket batting/roll and blown-in loose fill. Do not install in a
ceiling with spray foam type insulation. Any part of the fixture may
come in direct contact with any combustible material, such as a ceiling
joist or floor board.
3.
This fixture requires an existing ceiling surface, such as drywall, for
installation. To install this fixture, a hole needs to be made into the
ceiling surface at the desired location. Then, power supply wiring (NM
cable) needs to be installed from the power source to the hole.
4.
This fixture is designed for ceiling surfaces that are 3/4" thick or less.
Do not use this fixture on ceiling surfaces that are thicker than ¾".
5.
This fixture may be installed over a wet or damp location such as a
shower stall or bathtub enclosure. The area above the ceiling surface
must, however, be a dry location.
6.
To prevent wiring damage or abrasion, do not expose wiring to edges
of sheet metal or other sharp objects.
UNPACK THE FIXTURE
Check the contents of the box. You should have:
1 – Fixture
1 – Hole Template (4 ¼" (10.8 cm) diameter)
3 – Wire Connectors
INSTALLING THE FIXTURE
NOTE: First turn off electricity at the circuit breaker or the fuse box. Turning
the power off by using a wall switch is not sufficient to prevent electrical
shock.
1.
Choose the location for the fixture, taking into consideration the 5"
depth clearance requirement, the location of ceiling joists and the
accessibility for the electrical supply. Mark the selected location with a
circle using the provided template.
Using a keyhole saw make a 4 ¼" (10.8 cm) hole in the ceiling surface.
2.
(Fig. 1) (Note: Be sure not to make the hole any larger than specified
by the template.
An oversized hole may not allow for proper
installation.)
Ceiling
LED 4" RECESSED DOWNLIGHT INSTALLATION
INSTRUCTIONS – Easy-UP™ MODEL EV40543BMJ
Be sure to read these
Hole
Fig. 2
Cable
ALL RIGHTS RESERVED. COPYRIGHT  Envirolite 2018
WARNING - RISK OF ELECTRIC SHOCK. DISCONNECT
MAIN POWER AT FUSE OR CIRCUIT BREAKER
BEFORE INSTALLING OR SERVICING THE FIXTURE.
3.
Run non-metallic (NM) cable (also known as Romex) from your circuit
breaker or fuse panel to the hole, providing 6" (15,2 cm) to 8" (20,3 cm)
of slack extending below the hole. Cable having up to 12 AWG wiring
may be used. (Fig. 2) (WARNING - Use cables having wires rated
90°C or more.)
Ceiling joist
Ceiling
4.
Open the door of the junction box. Insert about 5 or 6 inches of the NM
cable into the junction box through one of the provided strain-relief slots.
(Fig. 3)
Remove at least 3" of the cable's outer sheath and remove the plastic
5.
or paper over-wrap. Strip approximately 3/8" of insulation from the ends
of all supply wires. Using the wire connectors, make the following wire
connections within the junction box (Fig. 3):
WHITE Fixture Wire
to
BLACK Fixture Wire
to
Fixture GROUND Wire
to
6.
Carefully stuff the wires and the wire connections into the junction box.
Close the junction box top door. Tighten the fastening screw.
7.
Raise the fixture up to the ceiling hole, while simultaneously pushing
the excess NM cable into the hole. (Fig. 4)
8.
Flip up and squeeze the spring-loaded wings against the junction box,
as shown, and insert the fixture into the hole, junction box first. (Fig. 4)
QUESTIONS? CALL TOLL
1-855-573-6156
FREE
Fig. 1
WHITE (NEUTRAL) Supply Wire
BLACK (HOT) Supply Wire
Supply GROUND Wire
Door
Junction Box
Wire Connector
Fig. 3

Publicidad

Tabla de contenido
loading

Resumen de contenidos para Envirolite Easy-UP EV40543BMJ

  • Página 1 NM cable into the hole. (Fig. 4) Flip up and squeeze the spring-loaded wings against the junction box, as shown, and insert the fixture into the hole, junction box first. (Fig. 4) Hole Ceiling Fig. 2 Cable ALL RIGHTS RESERVED. COPYRIGHT  Envirolite 2018...
  • Página 2: Troubleshooting

    For a complete list of compatible dimmers, please look up the item number This device may not cause harmful interference, and listed on the cover of this instruction manual at www.envirolite-LED.com. This device must accept any interference received, including interference that may cause undesired operation.
  • Página 3: Antes De Comenzar

    Con una sierra de calar crea un agujero 4¼” (10,8 cm) de la superficie del techo. (Fig. 1) (Nota: Asegúrese de no hacer el agujero más grande que especificado por la plantilla. Un agujero de gran tamaño puede evitar la instalación correcta.) Fig. 3 TODOS LOS DERECHOS RESERVADOS. PROPIEDAD INTELECTUAL  Envirolite 2018...
  • Página 4: Mapa De Distribución De Luz

    El uso indebido, accidente, instalación o cumplimiento de este equipo con la Parte 15 de las Reglas de la FCC y no mantenimiento incorrectos invalidarán también la garantía. debe ser operado. TODOS LOS DERECHOS RESERVADOS. PROPIEDAD INTELECTUAL  Envirolite 2018...
  • Página 5: Avant De Commencer

    (10,8 cm) de diamètre dans la cloison du plafond. (Fig. 1) (Note: veiller à ce que l’ouverture ne dépasse pas les dimensions prescrites par le Une ouverture trop grande pourrait nuire à l’installation gabarit. adéquate du luminaire.) Fig. 3 TOUS DROITS RÉSERVÉS  Envirolite 2018...
  • Página 6: Carte De Répartition De La Lumière

    Cette garantie vous confère des droits spécifiques, en sus des autres droits dont vous pourriez bénéficier et qui peuvent varier d’un État à l’autre. Toute utilisation incorrecte, accident, installation inadéquate ou entretien déficient aura pour effet d’annuler la présente garantie. TOUS DROITS RÉSERVÉS  Envirolite 2018...

Tabla de contenido