Spray Bar Assembly Instructions - Hog Slat Grower SELECT HSES Manual De Instalación

Evaporative Cooling System
ENSURE SUPPLIED TEFLON TAPE IS USED ANYWHERE A THREADED CONNECTION OCCURS
SPRAY BAR PLUMBING INSTRUCTIONS
1. Begin plumbing assembly by placing Spray Bars on Spray Bar Supports for the length of the system.
2. Align Spray Bar so holes are oriented as shown below in Figure 18.
3. Using self tapping screws (60926), fasten spray pipe together to eliminate separation and rotation.
4. On the ends of the spray line install a dog leg assembly as shown below in Figure 19. (If system has dual
pumps this step should be excluded)
Hog Slat Inc. Newton Grove, NC USA November 2018

Spray Bar Assembly Instructions

Figure 18
Figure 19
17