Control Panel; Turning The Unit On And Off - Ferroli SKY ECO F Serie Instrucción De Uso, Instalación Y Mantenimiento

SKY ECO F
1 USER'S MANUAL
1.1 Introduction
The new SKY ECO F is an instantaneous, high-performance, low-emission heater for
domestic hot water production, powered by natural gas or LPG and equipped with a
compact, WATER-COOLED burner, electronic ignition, up to 30% flame modulation,
sealed chamber, MODULATING fan, and control system with microprocessor.

1.2 Control panel

1 2
6 7
1 Key for increasing the DHW temperature
2
Key for decreasing the DHW temperature
3 Multifunction display
4 Reset key
5
On/Off key
6
OFF symbol
1.2.1 Display during operation
DOMESTIC HOT WATER
When hot water is requested (using the hot water tap), the control panel screen will show
the current DHW outlet temperature.
This temperature will increase or decrease as the DHW sensor temperature reaches the
preset value.
In the event of a malfunction (see section 3.4), the LCD panel will display the error code,
along with "d3" and "d4" during the waiting periods.

1.3 Turning the unit on and off

• Plug the unit into the mains.
• Press the ON/OFF key on the control panel for 1 second.
fig. 2 - Turning the unit off
3 4 5
8 9 10
fig. 1 -
7 Burner on and current power display.
When flashing, this indicates a combustion
fault.
8 DHW operation display
9
Connection for technical support
10 LCD panel
When the unit is off, the card remains connected. DHW production is deactivated.
• To turn on the unit, press the
the version of the software on the card for the first 5 seconds, followed by the current
DHW outlet temperature.
• Open the gas cock located before our unit. The unit will operate whenever domestic
hot water is demanded.
1.4 Adjusting the DHW
• Press the and
and 50ºC. As you can see, the (ºC) symbol flashes as the adjustment keys are pressed.
code A73022090
key again for 1 second. The LCD panel will display
fig. 3 - Turning the unit on
fig. 4 - In operation
keys to adjust the DHW temperature between 40ºC
fig. 5 - Minimum temperature
fig. 6 - Maximum temperature
EN
43