Eurosteam ® can be used horizontally or vertically
How do I clean my iron?
See page 7 section 6
Why does the orange light come on while the iron is in use?
When the water inside the boiler begins to cool, the orange light will come on indicating that
the iron is heating. Once the water in the boiler reaches the optimal temperature, the orange
light will shut off. It is very normal to see it repeating itself. Especially if you are ironing for
more than 10 minutes at a time, just keep ironing.
Why does my iron loose pressure while steaming?
As you use the steam button or steam dial, the pressure within the boiler is decreasing. You
may notice your iron slightly losing pressure when you are priming the boiler. Or if the oran-
ge indicator light has come on, you may choose to allow your iron to rebuild the pressure
until the indicator light on the handle goes off.
Why is my iron heating, but not producing any steam?
*Adjust the steam dial to the non continuous steam
position and press the button
*Ensure that there is water inside the boiler
*Your iron may need to be cleaned. See page 7 section 6 for cleaning instructions
Why is steam leaking from the screw cap when I turn my iron on?
*O-ring may need to be replaced. Remove O-ring from base of safety cap and replace with
O-ring provided.
*The screw cap may not be on tight enough
*When the iron is left on non continuous steam mode without releasing the steam button
regularly after indicator lamp on top of the handle shuts off for prolonged periods of time (10
minutes or longer) the iron's built in safety feature will release the steam through the screw
plug. We encourage quilters and sewers to please press the steam button every 10
minutes or so when not in use, this will ensure the iron to be ready when you are.
*If none of the above correct the problem please contact Customer Service
Canada 1.877.387.7770
USA 1.877.462.5757
Why is my handle getting hot?
Your Eurosteam® Evolution handle will get fairly warm, however it should never become too
hot to hold. Your iron's handle may feel warm due long periods of on with no use, leaving the
iron to steam continuously or steam leaking from the safety cap (see above).
9
TROUBLE SHOOTING/FREQUENTLY ASKED QUESTIONS