Initial Setup - Klip Xtreme BluBlade KSB-100 Guía De Instalación Rápida

5. Drive the supplied eight screws into the holes to firmly fasten each bracket
to the wall.
6. Align the hooks attached to the back of the unit with the brackets you just
installed. Then carefully slide the soundbar down so that the hooks rest securely
on both brackets. The wall installation is now complete.

Initial setup

1. Start by pulling the plastic tab from the battery to operate the remote control
included with the soundbar.
2. Then proceed to connect the supplied stereo to RCA adapter cable or the
3.5mm cable into any of the auxiliary jacks if using a wired connection with
your flat TV, computer or mobile device.
3. Next, insert the other end of the 3.5mm cable or the RCA adapter ends into
the output jacks on your TV, computer or audio device.
USB AUX2
TV
AUX1 DC 19V ON OFF
Swtich