Tripp-Lite SRWALLBRKT2U Guia De Instalacion

SRWALLBRKT Vertical Wall Bracket
SRWALLBRKT2U
175 lb. (80 kg) Max
Contents
M6 Screw x12
Installation
CAUTION: DO NOT EXCEED MAXIMUM LISTED WEIGHT CAPACITY. SERIOUS INJURY OR PROPERTY DAMAGE
MAY OCCUR!
1
Mount the bracket to a wall. Choose appropriate hardware
according to the weight load and mounting surface.
• Installers are responsible to provide hardware.
• Installers must verify the supporting surface will safely support
the combined load of the equipment and all attached hardware
and components.
• If mounting to wood studs, make sure
mounting screws are anchored
into the center of the studs.
Use of a stud finder is
highly recommended.
PROTECT YOUR INVESTMENT!
Register your product for quicker service
and ultimate peace of mind.
You could also win an ISOBAR6ULTRA
surge protector—a $100 value!
www.tripplite.com/warranty
Installation Guide
Español 2 • Français 3
175 lb. (80 kg) Max
M6 Cage Nut x12
"
1 6
m ]
6 m
[ 4 0
2U bracket panel shown.
"
1 6
m ]
All brackets install the same,
6 m
[ 4 0
regardless of size.
SRWALLBRKT4U
2
Attach and secure equipment to the top
horizontal rails using four M6 Screws, Cup
Washers and Cage Nuts. Repeat for each
additional unit.
1111 W. 35th Street, Chicago, IL 60609 USA • www.tripplite.com/support
Copyright © 2017 Tripp Lite. All rights reserved.
1
SRWALLBRKT6U
200 lb. (90 kg) Max
M6 Cup Washer x12