2. Add the clean water into the base.
3. Insert the pump outlet into the water tube and align the holder notch
with the tab at the edge of the base. The fountain top will stand on the
base securely (Fig 2).
Fig 2
Water tube
Outlet
Pump
5
4. Place the Tea Light into the Tea Light holder at the base. Attach the
adaptor to the power cord (Fig 3). If replacement tea lights are
needed, we recommend using only long burning (5+ hours) tea lights.
Fig 3
Adaptor
Tea light
Power cord
Tea light holder
5. Plug the cord into 120V household outlet .The fountain is controlled by the
switch located on the power cord. If the pump doesn't operate, rotate in-line
switch once to turn "on" and once more to turn "off".
Note: Ensure that the electrical cord loops below the electrical outlet to form
a "Drip Loop".This will prevent water from running down the cord into the
electrical outlet (Fig 4).
Fig 4
Drip loop
7