Sennheiser ew 300 Serie Instrucciones Para El Uso página 48

48
Inserting and changing the battery
Slide the cover of the battery compartment
embossed arrow until it clicks audibly.
Open the cover.
Insert the 9 V PP3 battery (IEC 6 LR 61). Please observe correct polarity
when inserting the battery.
Close the battery compartment.
To remove the battery, push the small red lever
compartment towards the bottom side of the transmitter.
Note:
We recommend powering the transmitter by a standard PP3 alkaline
battery. If powered by a rechargeable 9 V battery, the operating time
will be drastically reduced.
Connecting the antenna
Screw the antenna
Connecting the microphone/line cable
Electret powering ("plug-in" power) is available at the AF input for powering
the microphone.
Connect the 3.5 mm jack plug
the AF input (MIC/LINE)
Lock the jack plug by screwing down the locking ring
Switching the transmitter on/off
Slide back the cover plate
Press the ON/OFF
LED lights up.
To switch the transmitter off, press the
appears on the display. You can then release the button. The red LED
goes off.
Muting the transmitter
Use the MUTE switch
(this switch does not switch off the
onto the antenna socket (M3 connection).
from the microphone/line cable to
.
.
button to switch the transmitter on. The red
ON/OFF
to noiselessly mute the transmitter's audio signal
transmitter).
in the direction of the
in the battery
.
button until "OFF"