Filling The Tank - Mitchell & Cooper crustastun CS01 Instalación Y Manual De Instrucciones

IMPORTANT
ENSURE THAT THE WASTE WATER VALVE IS IN THE CLOSED POSITION BEFORE FILLING THE TANK.
PREPARE THE SALT WATER
01
Pour 2 litres (4 pints) of warm water into a clean container and add 65g (2.3oz) of salt. Stir until
the salt is fully dissolved.
HALF FILL THE TANK WITH FRESH COLD WATER
02
Open the lid using the catch on the front of the lid. Use a suitable container to pour
approximately 10 litres (2.5 US gal) of fresh cold water into the tank. Take care not to spill the
water down the sides of the unit.
- 65g (2.3oz) TOTAL SALT CONTENT PER TANK OF WATER.
CLOSED
OPEN
WASTE WATER VALVE
(SHOWN IN CLOSED POSITION)

FILLING THE TANK

6
LID
RELEASE