2
1
5/16" x 2-1/2" Bolt
(8 used in this step)
NOTE: Please do not fully tighten all bolts until you finish assembling all parts. Once assembled, go
back and fully tighten all bolts. This will make the assembly easier.
1. Unpack the unit and confirm that you have all the hardware and required parts.
2. Align and attach the Stretchers (B) between two Side Frames (C) with eight 2-1/2" Bolts (1) and eight
Large Washers (2 and 3). Loosely tighten the bolts with 5 mm hex wrench.
Assembly Instructions
3
C
①
B
C
B
B
Large Lock Washer
(8 used in this step)
②
4
C
Large Flat Washer
(8
n this step)
used i
③