EN User manual
5/8 Port Fast Ethernet Switch | 5/8 Port Gigabit Ethernet Switch
Safety Instructions
• Read the user manual completely and carefull before use.
It is part of the product and contains important information for correct use.
• Keep this manual.
It must be available for uncertainties and passing the product.
Power Supply
Notes for network separation
The product has no power switch and may be used only in easily accessible
outlets to quickly remove it in an emergency and after use.
Voltage-free only when the plug is pulled.
• In case of emergency, during thunderstorms and after use, pull the product
on its plug housing!
Product and Power Supply
• Do not open the housing.
• Compare the specifications of product, power supply and peripherals.
These must be identical.
• Do not repair defective products by yourself, but contact the dealer or
the manufacturer.
• Do not modify or alter product nor accessories.
• Use only the supplied power supply.
Not meant for children. The product is not a toy!
• Secure packaging, small parts and insulation against accidental use.
• Avoid stresses such as heat and cold, moisture and direct sunlight,
vibration and mechanical pressure.
Risk of injury by stumbling and falling.
Description and Function
Ethernet Switches
This product is an ethernet switch which extends your home network without
big installation effort and enables networking of multiple PCs or other
Ethernet-enabled devices to one another or to the Internet. It supports auto-
negotiation that means other than to a hub, data packets are forwarded by
hardware address to the respective desired target device at a stroke. Auto-
MDI(X) automatically adjusts the transmitting and receiving power to the
communicating devices. The transfer method „Store and Forward"
guarantees a safe data transmission.
Display
PWR-LED is on:
device on, voltage supplied.
PWR-LED is off:
device off, no voltage supplied.
LAN 1-5/8-LED on:
device connected.
LAN 1-5/8-LED off:
no device connected.
LAN 1-5/8-LED flash: device transfers data.
Scope of Delivery
Article-No.
Scope of Delivery
71223, 93372
5 Prot Ethernet Switch, power supply, user manual
71224, 93373
8 Prot Ethernet Switch, power Supply, user manual
REV2019-09-03
V3.4 ir
Subject to change without notice.
Product picture
Specifications
Modell
71223
71224
Connectors
5xRJ45 female
8xRJ45 female
5xRJ45 female
DC female
DC female
(5,5 x 2,5 mm)
(5,5 x 2,5 mm)
(5,5 x 2,5 mm)
Operation
max. 10/100Mbps (half duplex)
max. 10/100/1000Mbps (half duplex)
max. 20/200Mbps (full duplex)
max. 20/200/2000Mbps (full duplex)
modes
control-transmission „Store and
forward"
Auto-Negotiation Auto MDI/MDIX
Dimensions
81 x 51 x 21
123 x 59 x 33
96 x 67 x 25
mm
mm
Weight
58 g
77 g
max 10/100 Mbps (half duplex)
max 10/100/1000 Mbps (half duplex)
Data rate
max 20/200 Mbps (full duplex)
max 20/200/2000 Mbps (full duplex)
Forwarding
IEEE 802.3 10Base-T
IEEE 802.3u 100Base-TX
IEEE 802.3x Flow Control
Power supply
Input
220-240 V~, 50/60 Hz, 0,2 A
Output
5V
, 1000 mA
Dimensions
22 x 55 x 75 mm
Cable Length
110 cm
Weight
50 g
Intended Use
We do not permit using the device in other ways like described
in chapter "Description and Function" or in the "Safety
Instructions". Use the product only in dry interior rooms.
Not attending to these regulations and safety instructions might cause fatal
accidents, injuries, and damages to persons and property.
Preparing
• Compare the specifications of product, power supply and peripherals.
These must be identical.
• Check the scope of delivery for completeness and property.
Connection and Operating
1.
2.
3.
The Ethernet switch is cascadable in any manner, this means also several
Ethernet switches can be used together.
The Ethernet switch works automatically and contains no operating
93372
93373
elements to operate during use.
•
8xRJ45 female
DC female
DC female
(5,5 x 2,5 mm)
Maintenance, Care, Storage, Transportation
control-transmission „Store and
forward"
The products are maintenance-free.
Auto-Negotiation Auto MDI/MDIX
• Clean only with a dry, soft cloth.
132 x 75 x 24
• Do not use cleaning agents and chemicals.
mm
mm
• Store cool and dry.
78 g
126 g
• Store the product out the reach of children and in a dry and dust-
protected ambience when not in use.
IEEE 802.3 10Base-T
• Keep and use the original packaging for transport.
IEEE 802.3u 100Base-TX
IEEE 802.3x Flow Control
Disposal Notes
As a consumer, you are committed by law to dispose electrical and
electronic devices to the producer, the dealer, or public collecting points at
the end of the devices lifetime for free. Particulars are regulated in national
right. The symbol on the product, in the user`s manual, or at the packaging
alludes to these terms. With this kind of waste separation, application, and
waste disposal of used devices you achieve an important share to
environmental protection.
WEEE No: 82898622
Packaging
yellow sacks and glass belongs in used glass bins.
DE4535302615620
Connect any of RJ45 ports of the Ethernet switch by shielded
network cable to your ADSL/Router.
Connect any of the RJ45 ports of the Ethernet switch by
shielded network cable to your PC and/or further ethernet-able
devices.
Connect the supplied power supply to the DC input of the
Ethernet switch and to a well reachable main socket.
To reset the thernet switch if necessary, unplug it for around
5 minutes from mains.
According to the European WEEE directive, electrical and
electronic equipment must not be disposed with consumers
waste. Its components must be recycled or disposed apart from
each other. Otherwise contaminative and hazardous
substances can damage the health and pollute the
environment.
Packaging can be disposed of free of charge at the suitable
collection points – paper belongs in paper bins; plastics belong in
Goobay® | by Wentronic GmbH
Pillmannstraße 12 | 38112 Braunschweig
Germany