Menabo PADDY Instrucciones página 8

Using the product
The main screen shows the status of the smart pad. If the child is not on the pad, the child's image is black
and white. When the child is on the pad, the image of the child is colored.
The PADDY smart pad connects to the APP and monitors the presence of the child. When the child is picked
up from the car seat, the smart pad turns off, while turning on again when the child is placed back in the car
seat. If the smart pad does not connect with the APP, it will beep 3 times every 10 seconds for 2 minutes, and
then every 60 seconds.
In case the driver walks away from the vehicle and the child has
been left in the car child seat, after a distance of approximately
10-15 meters, the driver will receive a message on his phone, such
as: "ATTENTION! (BABY'S NAME) HAS BEEN ABANDONED". At the
same time the phone will send a sound (beep) and visual (flashing
light) alarm with vibration.
If the alarm is not turned off by the driver within 30 seconds, the
APP will send a new message to all associated users, such as:
"(NAME OF THE CHILD) HAS BEEN ABANDONED AT GPS 22.3213N
113.9433E)
The associated users can access the map on the phone and view
the exact location where the child was left unattended, as shown
in figure 2 below. Then they can contact the other users and
proceed to rescue the unattended child.
8
Child on pad Child not on pad
Example of the map visualizing where
the child has been left unattended