Recording Videos - ION CAMOCAM Guida Rapida

3. We recommend a class 10 SDHC card.
3.3 Setting up Date and Time
Connect your camera to a computer and run the iON software from the MicroSD card folder.
You can set the date and time on the camera via the settings page. Please see section 4.1 to
open iON software
3.4 Installing the PODZ
1. Attach the PODZ to the back of the camera and rotate
clockwise until the two dots are aligned.
2. Slide the latch on the PODZ down to lock it.
WARNING: The latch must be locked in place to ensure the
waterproof seal is activated – failure to do so may cause water
leakage.

3.5 Recording Videos

Before starting to record, select the video resolution using the
Video Resolution Switch.
There are two methods for starting the video recording function. When the camera starts
recording, there will be a short vibration indicating recording has started. The LED indicator
illuminates RED throughout recording.
1. Whether the camera power is ON or OFF, simply slide the Recording Slide Switch
from STOP to REC to start recording.
2. When your camera is OFF and the Recording Slide Switch
location, press and hold the Power
recording.
To stop Recording, move the Recording Slide Switch
camera will vibrate and the LED indicator will illuminate GREEN to indicate the recording has
stopped. The camera will then enter Standby mode.
An additional option is to hold the Power
camera off. The camera will vibrate for two seconds and the Red LED light will turn off.
button to turn the camera ON and it will start
button to stop the recording and turn the
EN-5
is at REC
from REC to STOP .The