Technical Data; Noise Information; Vibration Information - Ratio AR12NM Manual De Instrucciones

TECHNICAL DATA

Type CDT1212KL (CDT-designation of machinery, representative of Battery-powered Drill)
Voltage
Charger voltage
No load speed
Number of clutch positions
Max torque(soft/hard)
Chuck capacity
Max. drilling capacity
Machine weight

NOISE INFORMATION

A weighted sound pressure
A weighted sound power
K & K 3.0 dB(A)
PA WA
Wear ear protection when sound pressure is over: 80 dB(A)

VIBRATION INFORMATION

Vibration total values (triax vector sum) determined according to EN 60745:
Drilling into metal
Screwdriving without impact
The declared vibration total value may be used for comparing one tool with another, and may also be
used in a preliminary assessment of exposure.
WARNING: The vibration emission value during actual use of the power tool can differ from
the declared value depending on the ways in which the tool is used dependant on the following
examples and other variations on how the tool is used:
How the tool is used and the materials being cut or drilled.
The tool being in good condition and well maintained.
The use the correct accessory for the tool and ensuring it is sharp and in good condition.
The tightness of the grip on the handles and if any anti vibration accessories are used.
And the tool is being used as intended by its design and these instructions.
This tool may cause hand-arm vibration syndrome if its use is not adequately managed.
WARNING: To be accurate, an estimation of exposure level in the actual conditions of use
should also take account of all parts of the operating cycle such as the times when the tool is
switched off and when it is running idle but not actually doing the job. This may significantly reduce the
exposure level over the total working period.
Steel
Wood
L : 65 dB(A)
pA
L : 76 dB(A)
wA
Vibration emission value a
Uncertainty K = 1.5 m/s²
Vibration emission value a
Uncertainty K = 1.5 m/s²
100-240 V ~ 50/60 Hz
0-350 / 0-1250 /min
= 2.242 m/s²
h
= 1.158 m/s²
h
12 V
18+1
18 N.m
10 mm
6 mm
19 mm
0.97 Kg
31