IKEA RODULF Manual Del Usuario página 6

QUICK GUIDE
Manual reset / first use:
• Perform a reset by simultaneously
pressing the up and down buttons for
at least 8 seconds. Keep holding the
buttons and the desk will slowly move
to the lowest possible point. Reset is
complete when the desk has stopped
at the lowest point.
Follow these instructions when
adjusting desk height:
1. Make sure no objects are in the way
of the desk height adjustment range.
2. In order to run the desk up or down,
press the man oeuvre button up or
down, respectively.
Press the up button and continue to
hold until desired desktop height is
reached.
Press the down button and continue
to hold until desired desktop height is
reached.
To access full stroke
• Release the down button at the
lowest safe point and then press the
down button again for 5 seconds.
The desk will move to the mechanical
lowest height to have full stroke
access.
Simple memory
• To set memory/end positions:
• Move your desk to the level you want
to store.
• Press both buttons three times (0.5-1
second between each press).
• Then press "up" or "down" to set the
position (0.5-1 second).
• Do the same for your second stored
setting.
Collision detection
• The system is designed to avoid
possible damages to equipment due
to collision.
When desk detects a sudden
change in resistance it will stop the
movement and reverse approximately
50mm. 25mm of travel to activate in
both direction.
Safety regulations
• When the desk is run up/down, keep
the necessary safety distance to avoid
being trapped between the moving
desk top and fixed objects in the
surrounding area.
• When the desk is run up/down the
user should keep watch so that
nobody is injured or no object is
damaged. The desk top must not
bump into a fixed object in case it
overturns. Remove any office chair
before the desk is run up/down, each
time.
• The desk legs must not be altered
or reconstructed in any way. During
service and repair work of the desk,
the electrical cable must always be
disconnected from the wall socket.
• Modifications to the legs are
absolutely prohibited.
• The desk must not be used as a
hoisting device for people.
6