Parts And Components; Before Use - cecotec CONGA POPSTAR 4000 ULTIMATE Manual De Instrucciones

1. PARTS AND COMPONENTS

Fig. 1
1. High-efficiency filter
2. Dual cyclone filter (mesh and sponge filters)
3. Transport handle
4. Power button
5. Cord-winder button
6. Power controller
7. Dust-tank release button
8. Suction base
9. Telescopic tube
10. Flexible tube
11. Accessory for corners
12. Accessory for furniture
13. Brush for garments
14. Accessory-holder
Fig. 3
1. Power selector
2. Cord-winder button
3. On/off button

2. BEFORE USE

Remove all packaging elements.
Inspect all parts of the appliance for visual damage. Unwind the power cord completely and
inspect it for damage. Do not use the appliance if the device or its cord have been damaged or
are not working properly. In case of damage, contact the official Technical Support Service of
Cecotec for advise, repairs, or returns.
Make sure you have read and understood all instructions and warnings in this instruction
manual. Pay particular attention to the safety instructions on previous pages.
Attach the flexible tube to the air intake channel. Push until the tube locks with a click.
Fig. 2
Insert the end of the handle of the flexible tube into the telescopic tube.
Extend the telescopic tube by sliding the plastic button and pulling from the upper part of the
tube. Adjust its length to your liking.
Insert the telescopic tube into the floor brush.
Unplug the appliance from the mains supply before assembling or removing any accessory.
TOTALPURE 2000 CONNECTED
ENGLISH
33