Operation; Cleaning And Maintenance - cecotec CONGA POPSTAR 4000 ULTIMATE Manual De Instrucciones

ENGLISH

3. OPERATION

Once all parts are in place, unwind a reasonable length of the cord and plug the appliance into
a grounded wall outlet. A yellow mark on the power cord marks the ideal length. Do not pull
the power beyond the red mark.
Press the power button to turn the device on.
Suction power can be adjusted with the power controller on top of the appliance.
Use the most appropriate accessory depending on the kind of cleaning:
Accessory for furniture: Perfect for vacuuming on wardrobes, chairs, tables, etc. without
damaging them.
Accessory for garments : For all kind of garments and upholsteries (sofas, armchairs, etc.).
Accessory for corners: Vacuum the dirt on corners and sockets.
Once finished, unplug the appliance and use the cable-winder button to rewind the cord into
the appliance. Use one hand to press the button and guide the power cord with the other.
Fig. 3
Note: Please note that there is a safety switch inside the vacuum cleaner to prevent the unit
from being run at high vacuum rates. If the vacuum is too high, the safety switch will be turned
on. In this case, it can diminish the vacuum rate and protect the motor from being damaged.

4. CLEANING AND MAINTENANCE

Press the release button on top of the dirt container and remove it from the main body of the
appliance.
Press the button on the lower end of the container to open its lid and empty its contents.
Fig. 4
Clean the outside of the appliance with a damp cloth. Do not use abrasive cleaning agents as
they could damage the product.
Use the handle on top of the appliance to carry it.
Fig. 5
Cleaning of the filters
Dual Cyclone filter
Press the release button on top of the dirt container and remove it from the main body of the
appliance.
Hold the container's body and rotate its upper lid counterclockwise to remove it.
Remove the Dual Cyclone system.
If the sponge filter is so dusty that suction does not return to 100 %, then it is recommended to
rinse it under running water and leave it to dry over 24 hours before attaching it to the vacuum
cleaner.
34
TOTALPURE 2000 CONNECTED