Package Contents; Cleaning And Maintenance - PROZIS THE BEAST Manual Del Usuario Y Garantía

User Manual

PACKAGE CONTENTS

1 x Prozis THE BEAST - All-Terrain Military Vehicle
1 x USB charging cable
1 x Battery (car)
1 x Transmitter
1 x Quick guide

CLEANING AND MAINTENANCE

• Switch off the device and remove all plugs before cleaning.
• Do not use aggressive or abrasive cleaning agents, or materials such as scouring milk or
steel wool while cleaning the components. These may damage the device's surface.
• Protect the device from water drops and water spray.
• Use only a clean, dry cloth to clean the model.
• Do NOT use corrosive liquids.
• Use a slightly damp cloth and a mild cleaning agent to remove any stubborn dirt.
• Make sure moisture does not enter the product while cleaning to prevent damage to the
product and related repairs.
STORAGE
• Remove the batteries if the product is not to be used for a longer period of time.
• When not using the device, store it in a dry environment, protected from dust and direct
sunlight.
• Recharge the device on a regular basis, if you do not use it regularly. This helps maintain
battery performance.
• Store the device in its original packaging.
Instructions
Product description: see page 2, figure A
1. Trimmer 2. Battery compartment 3. On/Off button
4. Left/Right button 5. On/Off button 6. Indicator light 7. Forward/Backward button
Battery charging and installation: see page 2, figure B
1. The battery must be charged before first-time use. Connect the USB plug to any USB
power source, and the battery connector to the other end of the cable. Charge the battery for
a minimum of 3 hours for the first two times. The subsequent charging time is 2 to 3 hours.
Do not overcharge as it won't charge the battery with more power. Examine the toy regularly
(battery and charger included) for any damage. In the event of damage, it must not be used
until such damage has been repaired.
2. Open the vehicle's battery cover and install the battery pack. Lightly screw it using a
screwdriver. Open the transmitter's battery cover, install 2x1.5V AA batteries with the correct
polarity as shown inside the battery compartment.
EN
6