essentiel b Circus ECCM1 Instrucciones De Uso página 18

4. Place the extractor head into the heating position. Place the extractor head on the shaft,
fitting the attachment pins of the rotation shaft firmly into the grooves of the extractor head.
In case of bad positioning the sugar will not heat up enough and there will be no production
of filament.
5. Connect the cotton candy maker to the socket.
6. Turn the switch to "I" position and allow to run for at least 2-4 minutes, this will allow it to
warm up then switch to "O" position.
7. Pour one spoon of sugar with the provided measuring spoon into the center receptacle of
the extractor head. Switch to "I" position.
NOTE: Never use ingredients other than pure granulated sugar, this will cause clogging.
Do not overfill the sugar receptacle.
8. Use the bamboo sticks or use a normal piece of paper and make a roll out of it. Use this as
the stick to roll up the cotton candy. You shall hold the stick horizontal over the transparent
part and go from left to right when you roll up the cotton candy. The measuring spoon can
be used as a stick too.
Note: It takes about 2 to 3 minutes to make a cotton candy.
Attachment pins of the rotation shaft
- 18 -
Grooves of the extractor head