ASROCK H61M Manual Del Usuario página 21

Tabla de contenido

Publicidad

2.8 Onboard Headers and Connectors
Onboard headers and connectors are NOT jumpers. Do NOT place
jumper caps over these headers and connectors. Placing jumper caps
over the headers and connectors will cause permanent damage of the
motherboard!
Serial ATAII Connectors
(SATA2_0: see p.2, No. 11)
(SATA2_1: see p.2, No. 12)
(SATA2_2: see p.2, No. 14)
(SATA2_3: see p.2, No. 15)
Serial ATA (SATA)
Data Cable
(Optional)
USB 2.0 Headers
(9-pin USB6_7)
(see p.2 No. 17)
(9-pin USB8_9)
(see p.2 No. 13)
Infrared Module Header
(5-pin IR1)
(see p.2 No. 19)
These four Serial ATAII
SATA2_0
(SATAII) connectors support
SATA2_1
SATA data cables for internal
storage devices. The current
SATA2_2
SATAII interface allows up to
SATA2_3
3.0 Gb/s data transfer rate.
Either end of the SATA data
cable can be connected to the
SATA / SATAII hard disk or the
SATAII connector on this
motherboard.
Besides six default USB 2.0
ports on the I/O panel, there
are two USB 2.0 headers on
this motherboard. Each
USB 2.0 header can support
two USB 2.0 ports.
USB_PWR
P-9
P+9
GND
DUMMY
1
GND
P+8
P-8
USB_PWR
This header supports an
IRTX
+5VSB
optional wireless transmitting
DUMMY
and receiving infrared module.
1
GND
IRRX
ASRock H61M Motherboard
21

Publicidad

Tabla de contenido
loading

Tabla de contenido