Assembly and Instruction Sheet
Augusta Fireplace
Model: AD572
Important!
Please read and follow ALL instructions before assembling or using this
product, particularly the safety statements. Failure to follow instructions
and warnings could result in damage to property, serious injury or death.
WARNING!
• Outdoor use only. Never use in enclosed area. Use in
unventilated areas will endanger your life.
• Do not use this unit on or near combustible surfaces or
structures such as wood decks, dry leaves or grass, vinyl or
wood siding, etc.
• Use on level, non-combustible surface only.
• Keep away from all combustible materials including gasoline
and other flammable liquids and vapors.
• Never use flammable accelerants, such as: gasoline, alcohol,
paint thinners, kerosene, etc. to start a fire. Serious injury or
property damage could result.
• Screen lifting tool may become hot when in use! Failure
to wear protective gloves may lead to injury.
• Always wear fire-resistant gloves when handling hot
metal screen and lifting tool.
• Keep away from house, garage, balconies, or overhangs.
• Avoid using during dry or windy conditions.
• Keep out of reach of children.
• Do not overfill or use to burn leaves or trash.
• Exercise the same care you would with an open fire.
• Never leave unit unattended while hot or in use.
• Completely extinguish fire before leaving.
• Ashes can remain hot for a long time after fire is extinguished.
• Dispose of cold ashes properly.
• Any modification of the unit will void product warranty.
Contact local authorities regarding possible burn
restrictions before using product.
Parts Check List
Tools Required:
• Phillips Head Screwdriver
• Adjustable Wrench
Part #
Quantity
Part Description
A
4
Basin Legs
B
1
Basin
C
1
Hardware Pack
D
1
Storage Cover
E
1
Roof Ring
F
1
Dome Roof
G
1
Dome Vent
S1
1
Screen Section with Latch
S2
1
Large Screen Section
S3
1
Large Screen Section
S4
1
Hinged Door
S2
S1
S3
G
S4
F
E
A
B
C
Please contact us if you have any problems or questions regarding this product.
Toll Free: (800) 230-6530, M-F, 9 a.m. - 5 p.m. EST.
Email: customerservice@asiadirectinc.net
Visit us online at: www.asiadirectinc.net
General Care
• Fire bowl may be cleaned with water and mild detergent.
• Do not use abrasive detergents or pads to clean surround or fire bowl.
• As with any outdoor grill, periodic maintenance is required to
return painted steel surfaces to original appearance. Remove any
rust with sandpaper or steel brush and repaint with grill paint suitable
for high-temperature surfaces. Follow manufacturer's instructions.
(continued on back)
Assembly Instructions
Step 1:
Carefully unpack all parts. Inspect for missing
parts or damage.
Step 2:
Align holes of Basin (B) with the holes of Stand Legs (A).
Insert screw through Leg and Basin holes, fasten with nut
(Fig. 1). Once all legs are attached, tighten screws and nuts
with screwdriver and wrench.
Step 3:
Attach screen sections with screws and bolts to Basin stand
in order shown (Fig. 2). Make sure door latch on part S1 is
facing upwards so door will lock properly (Fig. 2 inset).
Step 4:
Place Roof Ring (E) over assembled screen sections with
tabs facing up (Fig. 4). Align holes of screen sections and
ring. Insert screws through holes and fasten with nuts.
NOTE: S3 and Hinged Door (S4) will overlap over same
screw holes and attach with the same screws. Place Hinged
Door over S3 before inserting screws (Fig. 5-6).
Step 5:
Securely tighten all hardware with screwdriver and wrench
(Fig. 7).
Step 6:
D
Attach Handle to Hinged Door so the lock will rest in the
latch when door is closed. Both nuts and latch should be
fastened so all three parts are on the inside of the Hinged
Door. Securely fasten hardware with wrench (Fig. 8-10).
Step 7:
Attach Dome Vent (G) to Dome Roof (F) with hardware
(Fig. 11). Place dome roof on screen assembly (Fig. 12).
Congratulations! Your new fire pit is ready for outside use on
a level, non-combustible surface!
PLEASE READ ALL SAFETY WARNINGS BEFORE USE.
Figure 1
Figure 2
S2
S1
S3
S4
Figure 3
Figure 4
Figure 5
Figure 6
Figure 7
Figure 8
Figure 9
Figure 10
Figure 11
Figure 12
AD572OM (2/09)