Devon TREAD 2 Manual De Instrucciones página 5

O N / O F F
To turn the Tread 2 ON / OFF:
Push crown button IN momentarily D I S P L AY
and RELEASE.
If the Tread 2 is entering into ON
mode, the Time Belts will cycle
to the current time.
If the Tread 2 is entering
into OFF mode, the Time
Belts will advance to the
12:00 position and then
a d v a n c e t h e m i n u t e
belt to indicate battery
life (see Battery Life
Indicator).
All manuals and user guides at all-guides.com
down
push
hours
minutes
seconds /
battery life
up
T I M E S E T
The TIME SET mode of the Tread 2 allows the user
to adjust the time.
To enter TIME SET mode:
While the watch is turned on, push the crown
button IN for greater than 3 seconds until the hour
belt rotates a full revolution to indicate hour TIME
SET mode has been entered.
To adjust hour indicator belt one position:
Push crown lever DOWN and RELEASE.
To adjust hour indication belt multiple positions:
Push crown lever DOWN and HOLD.
Once the hour belt position is correct, push
crown button IN momentarily and RELEASE. The
Tread 2 will rotate the vertical belt a full revolution
to indicate minute TIME SET mode has been
entered.
To adjust minutes indicator belt one position:
Push crown lever DOWN and RELEASE.
To adjust minutes indicator belt multiple positions:
Push crown lever DOWN and HOLD.
To exit TIME SET mode:
Push crown button IN momentarily and RELEASE.
The Tread 2 will advance both the hour and
minute belts a full revolution to indicate the exit
from TIME SET mode.
NOTE: The Tread 2 will resume timekeeping at
zero seconds of the time that was set, therefore
performing this step at the instant a reference clock
hits 0 seconds will insure synchronization.