Timeslot Terminal Programming Procedure; Device Reset (To Restore Default Settings); Default Settings; Specifications - Urmet 1723/46 Manual Del Usuario

Either hold pressed for at least 5 seconds or leave the device inactive for more than 30 seconds to quit
programming mode.
The button turns from red to blue and the device switches to normal operation.

TIMESLOT TERMINAL PROGRAMMING PROCEDURE

By enabling the timeslot function, a timer (not included) may be used to program the periods of the day
when to activate the relays simply by pressing
Access programming mode.
Enter confi guration code 40 a where:
40 identifi es the programming function code
a defi nes the number of relays enabled during the timeslots.
1 = relay 1
2 = relay 2
0 = function off
Press to confi rm.
The device generates 3 confi rmation beeps and the button
If the entered code is wrong, the device will generate one long beep and wait for the correct code to be
entered.
Either hold pressed for at least 5 seconds or leave the device inactive for more than 30 seconds to quit
programming mode.
The button turns from red to blue and the device switches to normal operation.

DEVICE RESET (TO RESTORE DEFAULT SETTINGS)

Disconnect power from the device.
Hold the programming switch next to the terminal board pressed.
Power the device while the SW1 switch is pressed. A long beep will be heard.
Release the switch after 5 seconds.
The device will beep 3 times for confi rmation when the switch is released.
All the previously programmed codes, times and passwords will be deleted.

DEFAULT SETTINGS

Relay 1
Function
Activation time
Button confi rmation
Relay 2
Function
Activation time
Button confi rmation
Timeslot terminal

SPECIFICATIONS

Power voltage: ............................................................................................................... 12 Vac or Vdc ± 10%
Maximum draw: ................................................................................................................... 260 mA @ 12 Vac
Maximum stand-by consumption: ...................................................................................... 105 mA @ 12 Vac
Maximum switchable relay load: ......................................................................................12 Vac / 24Vdc 5 A
Inputs "A1", "A2" and "H": ....................................................................................... active if closed to GND
Degree of protection: ................................................................................ IP45 according to CEI EN 60529
Dimensions (W x H x D) ....................................................................................................... 98 x 120 x 30 mm
DS1723-008B
Monostable
200 ms
No
Monostable
200 ms
No
OFF
.
turns from red to blue to red.
150 mA @ 12 Vdc
50 mA @ 12 Vdc
13