Cleaning Instructions - noken arquitect 100207964 - N862000018 Manual De Instrucciones

CLEANING INSTRUCTIONS

GENERAL PRECAUTIONS
For best results in cleaning this surface, it is
important to remember certain precautions:
• although very durable, the surface must still
never be treated with products containing abrasive
substances, abrasive sponges (extra green abrasive
fibre) or unsuitable products media, such as
sandpaper or steel wool;
• products with a high content of acid or very alkaline
products should be avoided as they could stain the
surface;
• when using solvents, the cloth used must be
perfectly clean so as not to leave marks on the
surface. In any case, streaks can be easily removed
by rinsing with hot water and drying;
• avoid furniture polishes and wax based detergents
in general, because they tend to form a sticky layer
on the dense surface, to which the dirt adheres.
THERMAL HEALING
SUPERFICIAL
SCRATCHES
One of surface most innovative property is the
thermal healing of superficial micro scratches.
After the scratch, place a thin paper (kitchen/tissue
paper) between the iron and the damaged surface in
order to prevent further scratching produced by the
iron. The paper must be damp.
Place the iron on the paper on the damaged surface
for maximum 30 seconds at 120°C.
After ironing, wipe the surface and dry with a dry
cloth (microfiber cloth or kitchen/tissue paper). It
has been observed that after 100 cycles of removing
superficial micro scratches and repairs using the
iron, there is still no evidence of scratches on surface
(scratches made in the same area). If the structure
of the material is not permanently damaged, the
product can resist to more than 100 repair cycles of
superficial micro scratches.
12
Arquitect's top cabinet surface
terial, full of advantages. Some of its features are the complete opacity, anti-fingerprints
marks, and its soft hand feel. Furthermore, micro scratches can be thermo-repaired.
This material should be usually clean though does not need any special care. Almost all
normal household cleaning products or disinfectants work well with the material cleaning
(household degreasers rinsed with warm water). We suggest daily cleaning with a slightly
damp cloth.
In case of dirt resistance to house cleaning products, we suggest using non-aggressive
aromatics solvents (as acetone) due to the design and enclosure of the material. After using
this kind of solvents, it is very important to rinse the surface with a slightly damp microfiber
cloth and quickly dry it.
In the case of surface micro-scratches, we highly recommend following thermal-reparation
instructions.
OF
MICRO
is made with a new high-quality intelligent ma-
2
1
2
1
2
1
3
3