Atlantis Land WebShare 144WN Guía Rápida página 28

For more detailed instructions on configuring and using the
WebShare Wireless Router ADSL2+, please refer to the online manual
or Interactive guide on the CD (Vera).
Before beginning the configuration of the Router you have to know the
parameters of your subscription ADSL.
There are five ways ─ PPPoE, PPPoA, RFC1483 routed, IPoA, RFC1483
Bridge─ for the device to have a public IP address and then to access
Internet. You have to check with your ISP about which way is adopted.
VPI/VCI: Consult the telephone company to get the Virtual Path Identifier
(VPI) and Virtual Channel Identifier (VCI) numbers. The valid range for the
VPI is 0 to 255 and for the VCI is 32 to 65535. The default value VPI is 0
and VCI is 32.
VCI=50). NAT: The NAT feature allows multiple-user Internet access for
the cost of a single IP account. If you need to have a public server or a
public network, NAT has to be disabled.
Method: Be sure to use the encapsulation method (LLC/SNAP or VC
MUX) required by your ISP.
illustrated in the following table and keep it for reference.
PPPoE
PPPoA
RFC1483 Bridged
RFC1483 Routed
For BT (VPI=0, VCI=38) and for KC (VPI=1,
VPI and VCI
VC-based / LLC-based multiplexing
Username and Password
Service Name
VPI and VCI
VC-based / LLC-based multiplexing
Username and Password
VPI/VCI
VC-based / LLC-based multiplexing
VPI/VCI
VC-based / LLC-based multiplexing
IP address
Subnet mask
Default Gateway (IP address)
IP address (DNS)
WebShare 144WN
ENGLISH
Encapsulation
Gather the information as
28