Led Operation - Honeywell Home REM1000R1003/U Guia De Instalacion

Installation Guide

LED Operation

During normal operation the LED will be off when the remote is idle. If the LED
remains off when a button is pressed then the battery has failed.
After a button press the LED will function as follows:
• Green when a button is pressed.
• Quickly flashing red when the battery needs to be replaced.
• Slowly flashing amber when the remote is disconnected from the system.
• The LED will be off when the remote is idle.
During wireless connection to the system the LED will function as follows:
• Solid green for 15 seconds: connected to the system.
• Solid red: the remote did not connect to the system.
Disconnect from RedLINK System
Press and hold the CONNECT button on the remote until the LED glows amber
(about 10 seconds) to disconnect from the RedLINK system.
If you replace a thermostat or Equipment Interface Module, disconnect the remote from the old device. Then follow the
steps on page 1 to re-connect the remote to the wireless network.
Operation
The remote has three buttons. The button that is pressed sets the thermostat to
that setting of the program schedule. That setting is held until another button is
pressed on the remote or the regular program schedule is resumed at the ther-
mostat.
Residential model:
• Home: Sets the thermostat to the Home setting of
the program schedule.
• Away: Sets the thermostat to the Away setting of the
program schedule.
• Vacation: Sets the thermostat to the Vacation setting
of the program schedule.
Commercial model:
• Occupied: Sets the thermostat to the Occupied
setting of the program schedule.
• Unoccupied: Sets the thermostat to the Unoccupied
setting of the program schedule.
• Holiday: Sets the thermostat to the Holiday setting
of the program schedule.
69-2592EFS—05
2
M33097