Publicidad
Idiomas disponibles
Idiomas disponibles
Installing the Photocell:
Caution: Only with approved controls which are suitably rated with the specific unit.
1. Make sure power is OFF and power console is NOT plugged into an electrical outlet.
2. Open front cover of transformer. Locate the jumper connector on the panel and unplug from the panel
plug receptacle. (Save the jumper connector with these instructions for possible future use).
3. Remove the 7/8" diameter knockout from the side of the transformer and push the photocell's white
connector through the knockout hole. Inside the housing, slide the star nut over the white connector,
thread it onto the photocell and tighten.
4. Plug the photocell's white connector into the plug receptacle in the panel. Ensure that the plastic
connectors are firmly connected.
5. Position photocell so that no artificial light will shine on it, failure to do this will cause the photo control
to cycle on and off.
6. In the unlikely event that the photocell should fail, the light fixtures may remain on, even during the
daytime. If this should happen, follow these instructions, and remove the defective photocell and place
the jumper connector in its place.
6. Replace the front cover and secure. Turn on power.
Installing the Plugin Timer:
Our transformers are supplied with a power outlet for attachment of a timer module. For correct operation
follow the instructions supplied with the timer module.
Publicidad
