Custom Overlay Panel Installation - KitchenAid KUWR214KPA Guia De Uso Y Cuidado E Instrucciones De Instalacion

Dispose of and/or recycle all packaging materials.
After all packaging materials have been removed, clean the
inside of your wine cellar. Refer the cleaning instructions in
"Cleaning" section.
NOTE: For standard stainless steel or glass door models,
skip to "Door Closing" section.

Custom Overlay Panel Installation

IMPORTANT:
Create custom overlay panel according to the specifi cations
in the "Custom Overlay Panel" section.
KitchenAid is not responsible for the removal or addition of
molding or decorative panels that would not allow access to
the wine cellar for service.
1. Open the door completely to 90°.
2. Remove the gasket from the corners of the door, pulling
gently until the two screw holes in each corner of the
door can be seen.
NOTE: The gasket does not have to be removed from
the door, only the corners.
A. Screw holes
B. Gasket
6
90°
A
A
B
3. Using two people, hold the custom overlay panel against
the door. Be sure that the top and bottom hinges fit
accurately into the routing on back of the custom wood
panel.
NOTE: Handle needs to be installed before the custom
overlay door panel has been installed on the wine cellar
door.
4. Fasten the custom panel to the door using two wood
screws (provided in installation kit) at each corner.
A
A. M4 x 30 fl athead screws (provided in installation kit)
5. Press the gasket firmly back into it's original position.
A