Storage; Specifications - Sears CRAFTSMAN ZTS 7500 Manual Del Operador

STORAG E
Before
Storage
Before you store your unit for the off-season, read the
Maintenance and Storage instructions in the Safety
Rules section, then perform the following steps:
• Turn the mower blades OFF, set the ground speed
control levers to START / PARK, & remove the key
from the ignition switch.
• Check all fluid levels. Check all maintenance items.
• Battery life will be increased if it is removed, put in a
cool, dry place and fully charged about once a
month. If the battery is left in the unit, disconnect the
negative cable.
It is important to prevent gum deposits from forming in
the essential fuel system parts such as the carburetor,
fuel filter, fuel line, and fuel tank during storage. Also,
alcohol blended fuels (called gasohol or using ethanol or
methanol) can attract moisture which leads to the
separation and formation of acids during storage. Acidic
gas can damage the fuel system of an engine while in
storage.
WARNING
Never store the unit (with fuel) in an enclosed,
poorly ventilated structure. Fuel vapors can
travel to an ignition source (such as a furnace,
water heater, etc.) and cause an explosion.
Fuel vapor is also toxic to humans and animals.
To avoid engine problems use fuel stabilizer, especially
before storage of 30 days or longer.
After
Storage
Before starting the unit after it has been stored:
• Check all fluid levels. Check all maintenance items.
• Fill with FRESH fuel.
• After starting, allow the engine to warm before
operating.
NOTE: Specifications are correct at time of printing and are subject to change without notice.
ENGINE:
Make
Model
Horsepower*
Displacement
Electrical System
Oil Capacity
CHASSIS:
Fuel Tank
Rear Wheels
Front Wheels
Briggs & Stratton
Intek
26 @ 3600 rpm*
44.2 Cu. in (724cc)
12 Volt, 16 amp. Alternator, Battery: 340 CCA
64 Oz. (1.9L)
Capacity: 3.25 Gallons (12,3 L)
Tire Size: 18 x 8.5-8
Inflation Pressure: 10-12 psi (,69-,83 bar)
Tire Size: 11 x 4-5
Inflation Press.: 18-20 psi (1,24-1,30 bar)
TRANSMISSION:
Type Hydro-Gear EZT ZC-AHBB-2A7B-1DPX
Hydraulic Fluid 20w 50 Premium Engine Oil
Continuous Torque 115 ft-lbs
Output
Maximum Weight 340 Ibs
on Axle
*Briggs & Stratton Models: The gross power rating for individual gas engine models is labeled in accordance with SAE (Society of
Automotive Engineers) code J1940 (Small Engine Power & Torque Rating Procedure), and rating performance has been obtained
and corrected in accordance with SAE J1995 (Revision 2002-05). Torque values are derived at 3060 RPM; horsepower values are
derived at 3600 RPM. Actual gross engine power will be lower and is affected by, among other things, ambient operating conditions
and engine-to-engine variability, Given both the wide array of products on which engines are placed and the variety of
environmental issues applicable to operating the equipment, the gas engine will not develop the rated gross power when used in a
given piece of power equipment (actual "on-site" or net horsepower). This difference is due to a variety of factors including, but not
limited to, accessories (air cleaner, exhaust, charging, cooling, carburetor, fuel pump, etc.), application limitations, ambient
operating conditions (temperature, humidity, altitude), and engine-to-engine variabiliOz Due to manufacturing and capacity
limitations, Briggs & Stratton may substitute an engine of higher rated power for this Series engine.
30