NAMCO NINJA ASSAULT DX Manual Del Operador página 35

5-1 Fitting the Header and Speaker Assemblies
The fitting position of the Header Assembly is very high, and it is important
that a means of reaching the height safely , without stretching, is available
(e.g. steps, step stool etc.)
1. Remove 4off Button head screw (M5x12) and remove the Top Cover.
Button head screw (M5x12)
2. Fit the Header Base assy to the top of the Monitor Cabinet with 2off pozi
head screws (M6x16), with flat washers.
Header base assy
3. Connect the connector and refit the Top Cover using the 4off Button head
screws (M5x12).
Top cover
Pozi head screw (M6x16)
with Flat washer
Page 35
Button head screw (M5x12)