Publicidad
A.
B.
H.
C.
D.
I.
J.
E.
K.
L.
M.
F.
G.
CAPABILITIES
Will shred: Paper, small paper clips, credit cards and staples
Will not shred: CD/DVDs, Continuous forms, adhesive labels, transparencies,
newspaper, cardboard, large paper clips, laminates or plastic other than noted above
Paper shred size:
Cross-Cut . ............................................................5/32 in. x 2 in. (3.9mm x 50mm)
IMPORTANT SAFETY INSTRUCTIONS — Read Before Using!
• Keep away from children and pets. Keep hands away from paper entry. Always
set to off or unplug when not in use.
• Keep foreign objects – gloves, jewelry, clothing, hair, etc. – away from shredder
openings. If object enters top opening, switch to Reverse (R) to back out object.
15
• Never use aerosol products, petroleum based lubricants or other flammable
products on or near shredder. Do not use canned air on shredder.
• Do not use if damaged or defective. Do not disassemble shredder.
15
Do not place near or over heat source or water.
• Operation, maintenance, and service requirements are covered in the instruction
15
manual. Read the entire instruction manual before operating shredders.
Warning: Changes or modifications to this unit not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment. NOTE: This equipment
has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause
harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
2
DS-3_406563_3L_NA_100711.indd 2-7
ENGLISH
Model DS-3
KEY
A. Shredder head
E. Waste opening
I. Handle
J. Safe Sense
®
override switch
B. S afeSense
®
F. Bin full indicator
Technology (yellow)
G. Basket
C. Paper entry
H. Disconnect power switch
D. S ee safety
1. OFF
Active
Not Active
instructions below
2. ON
K. Grips
L. Overheat (red)
M. Control switch
1. Auto-On (green)
R 2. Reverse
Maximum:
Sheets per pass ..................................................................................................10*
Cards per pass . ...................................................................................................... 1
Paper width . ........................................................................................9 in./229mm
*20 lb., 8.5 in. x11 in. paper at 120v, 60 Hz, 3.8Amps; heavier paper, humidity or other than
rated voltage may reduce capacity. Recommended maximum daily usage rates: 100 sheets,
5 credit cards.
10 sheets per pass.
Fellowes SafeSense
shredders are designed to be operated in home and office
®
e nvironments ranging between 50 – 80 degrees Fahrenheit (10 – 26 degrees Celsius) and
40 – 80% relative humidity.
• This shredder has a Disconnect Power Switch (H) that must be in the ON ( )
position to operate shredder. In case of emergency, move switch to OFF (O) position.
This action will stop shredder immediately.
• Avoid touching exposed cutting blades under shredder head.
• Shredder must be plugged into a properly grounded wall outlet or socket of the
voltage and amperage designated on the label. The grounded outlet or socket
must be installed near the equipment and easily accessible. Energy converters,
transformers, or extension cords should not be used with this product.
• FIRE HAZARD – Do NOT shred greeting cards with sound chips or batteries.
• For indoor use only.
• Unplug shredder before cleaning or servicing.
FUNCIONAMIENTO BÁSICO DE LA TRITURADORA
Funcionamiento continuo:
máximo de 4-5 minutos
NOTA: la destructora funciona brevemente
después de cada pasada para limpiar la entrada.
Presione Encendido
El funcionamiento continuo durante más de 4 ó
automático ( )
5 minutos activará el período de enfriamiento de
20 minutos.
CARACTERÍSTICAS AVANzADAS DEL PRODUCTO
OPERACIÓN DE LA TECNOLOGÍA SAFESENSE
Detiene automáticamente la trituración cuando las manos tocan la abertura para papel.
CONFIGURACIÓN Y PRUEBA
1
2
D S - 3
1 5
Toque el área de prueba y
Coloque la trituradora en la
espere a que el indicador
posición de ENCENDIDO ( )
de SafeSense
se encienda
para activar SafeSense
®
®
MANTENIMIENTO BÁSICO DEL PRODUCTO
ACEITADO DE LA TRITURADORA
Todas las trituradoras de corte cruzado necesitan aceite para
brindar un máximo rendimiento. Si no se aceita la trituradora,
se puede reducir la capacidad de hojas, pueden aparecer ruidos
molestos al triturar y, en última instancia, es posible que deje de
funcionar. Para evitar estos problemas, le recomendamos aceitar
la trituradora cada vez que vacíe la papelera.
*Use sólo aceite vegetal que no sea en aerosol en un contenedor de boquilla larga, como el Fellowes 35250
PRECAUCIÓN
ADVERTENCIA:
SOLUCIÓN DE PROBLEMAS
Indicador de sobrecalentamiento: Cuando el Indicador de sobrecalentamiento está encendido, significa que la trituradora ha
sobrepasado la temperatura de operación y se debe enfriar. Este indicador permanecerá iluminado y la trituradora no funcionará
durante el transcurso del período de recuperación. En la sección Funcionamiento básico de la trituradora encontrará más información
sobre la operación continua y el tiempo de recuperación de esta máquina.
PAPEL ATASCADO
15
1
2
3
Presione y mantenga
Alterne lentamente hacia delante y hacia atrás
presionado Retroceso
(R) durante 2 ó 3
segundos
PAPEL/TARJETA
3
2
1
o
Introduzca el papel en
Introduzca el tarjeta en
la entrada y suelte
la entrada y suelte
D S - 3
®
D S - 3
3
SafeSense
está activa y
®
funciona correctamente
REALICE EL SIGUIENTE PROCEDIMIENTO DE ACEITADO Y REPÍTALO DOS VECES
2
1
3
D S - 3
Apague la trituradora
* Aplique aceite en la
Presione Retroceso (R)
entrada
durante 2 ó 3 segundos
15
5
6
4
Apague y
Hale suavemente del
Presione y mantenga
desenchúfela
papel sin cortar de
presionado Retroceso (R)
la entrada del papel.
Enchúfela.
D S - 3
4
Apáguela
7
10/24/11 4:34 PM
Publicidad
