Intex 28072 Manual Del Usuario página 7

LADDER SETUP (continued)
6. MAINTENANCE: Regularly check all nuts, bolts, step mounting fixtures and step
mounting pins to ensure all parts are secured properly and the ladder is sturdy.
7. BEFORE USE OF LADDER (refer to figure 6):
With all parts now in place, verify that all fasteners/screws are fully tightened and
apply downward pressure to each step to be sure they are fully anchored in place.
IMPORTANT: The removable steps side must be located outside of the pool.
8. AFTER USE OF LADDER (refer to figure 7):
1
9. Removing the steps from the secured position (refer to figure 8):
a) With your right hand pull and hold the latch towards you, while at the same time
with your left hand press the white protruding buttons and simultaneously lift that
leg out of the cavity exposing the lower white protruding buttons.
b) Allow the leg to rest over the top brace (make sure it does not fall back into the
cavity), and quickly lift up the "removable step assembly" out of its secured
position.
c) See step 5 for re-attaching the removable steps.
1
1
SAVE THESE INSTRUCTIONS
(289IO) 42" LADDER WITH REMOVABLE STEPS ENGLISH SIZE: 7.5" X 10.3" PANTONE 295U 05/27/2016
2
Press
and
Pull
1
2
3
Press
and
Pull
2
English
289A
6
7
8
3
Page 7