Washing Cycle; Cycle Selection And Start-Up; Turning Off The Machine - Elettrobar Niagara 281 Manual De Instrucciones

INSTRUCTION MANUAL FOR DISHWASHERS
GB
With reference to Fig. 2 , for correct operation of the machine, it is advisable to follow these rules:
•
Use a suitable rack, filling it without overloading it and without placing the dishes one on top of
the other. Always clean off the dishes beforehand, and do not load dishes with dry or solid
residue on them.
•
Place empty containers upside-down on the rack. Put the plates and similar kitchenware into
the special inclined rack, with the internal surface facing upwards. Put mixed silverware into
the special basket with the handles facing downwards.
•
Wash the dishes immediately after use, in order to prevent any residuals from hardening and
sticking on them.
•
Load the rack into the machine and close the door.
•
To avoid breakage, use only dishes that are intact and guaranteed for machine washing.
•
Do not place silver and stainless steel cutlery in the same basket, since this would cause the
silver to tarnish and the steel to corrode.
• Based on the type of dishes and their conditions, two types of cycles are available.
• Select a wash cycle that is suitable for the dishes to be washed by pressing the PROGRAMME
SELECTION key (2). The corresponding indicator will light up
• In order to get rapid drying, immediately remove the rack from the machine at the end of the
cycle.
• If you want to stop the washing cycle in advance, press the ON / OFF button ON/OFF button
(1).
• Automatic start is enabled after the first work cycle.
It suffices to lower the hood to start subsequent cycles. "AS" appears on the display to identify
this mode.
To disable this function, press the START (3) button (
open until "AS" disappears on the display.
All manuals and user guides at all-guides.com
•
To start the programme, press the START button (3) as
shown alongside. The corresponding cycle light flashes
°C
and the cycle starts.
•
When the cycle is complete, the indicator light for the
selected programme stays on steady.
Press the ON/OFF button (1) as shown alongside, and the
°C
corresponding indicator light will go off. On the DISPLAY (9),
two segments will remain on to show that power is being
provided.
6

4.3 Washing cycle

4.4 Cycle selection and start-up

Fig. 3
( ).
Fig. 4
) for five seconds with the hood

4.5 Turning off the machine