Testing Your Fan; Trouble Shooting Guide; Disposal Of Packaging And Product; Package Information - Svan SVVE52TM Manual Usuario

TESTING YOUR FAN

WARNING: Make sure wiring connection is correct before turning ON the main switch.
Fan with remote control
To use fan, press desire fan speed on remote control set and it should operate on Low, Med
and Hi speed. If you cannot operate this function, refer to the troubleshooting procedure
below.
Press OFF button to turn off the fan and always remember to switch off the main switch to
save energy. To use light (for model with light only), press light control button ON and light
should light up. If you cannot operate this function, refer to the troubleshooting procedure
below.

TROUBLE SHOOTING GUIDE

Minor problems often can be fixed without an electrician. Before doing any work, shut off
power supply to avoid electrical shock.
PROBLEM
Fail to operate
Cannot control speed or light

DISPOSAL OF PACKAGING AND PRODUCT

Dispose of packaging in an environmentally-friendly manner.
This appliance is labelled in accordance with European Directive 2012/19/EU
concerning used electrical and electronic appliances (waste electrical and
electronic equipment - WEEE). The guideline determines the frame work for
the return and recycling of used appliances as applicable throughout to the EU.
PACKAGE INFORMATION: Packaging materials of the product are manufactured from
recyclable materials in accordance with our National Environment Regulations. Do not dispose
of the packaging materials together with the domestic or other wastes. Take them to the
packaging material collection points designated by the local authorities.
CAUSE
Power is off or fuse is blown
Bad wire connection
Inconsistent location for dip
switch
Battery power is off
Bad wire connection
Light is off
SVAN TRADING S.L.
C/Ciudad de Cartagena, 20. Paterna (46988). SPAIN.
info@svanelectro.com
96060034
SOLUTION
Turn power on or check fuse
Turn power off. Loose
canopy, check all
connections
Set the dip switch to be the
same of transmitter and
receiver
Use a new battery
Turn power off and check
the receiver wiring is correct
Check the bulb is not burnt