Initial Operation; Manual Time Setting - FanJu FJ3365-Norcc Manual Del Usuario

2 INITIAL OPERATION AND NOTES

2.1 Initial Operation

 Open the weather station battery compartment, insert 2 x AA batteries
observing polarity [ "+" and " –" marks]
 Remove the battery compartment on the Wireless Remote Sensor, insert
2 x AA batteries observing the correct polarity (+ and - marks) and close
the battery compartment.
 When the power is connected all the icons on the LCD display will light up
for 3 seconds, you will hear a beep tone and the weather station will start to
detect the indoor temperature and humidity
 The weather station will start to make a connection to the outdoor remote
sensor. This operation takes about 3
minutes and is displayed by a flashing reception RF icon " " in the "Remote
Sensor" display area on the receiver.
2.2 Notes for Customer before Use
 If weather station failed to receive transmission from outdoor sensor ("- -
"display on the main station LCD), press and hold "-" button for 3 seconds to
receive transmission manually. RF icon " " flashes on t he LCD and the
weather
station to re-receive the data from outdoor sensor. Or
compartment, press the TX button to connect the sensor and station again.
3 TIME, TIME ZONE AND CALENDAR SETTING

3.1 Manual Time Setting

 Press the "MODE" button, can switch the display calendar, second or alarm
time
 Press and hold down the "MODE" button for 3 seconds, the 12/24 hour mode
display starts to flash. Now use"+" and
"-" buttons to set the correct 12/24 hour mode.
FJ3365-Norcc Manual
6
open the sensor battery