Rear Panel - Blackstar Amplification Live Logic Manual Del Usuario

Live Logic product buttons and features
P OW E R D C 9 V U S B M O D E E X P
C U S TO M PATC H 2 1
1 2
Front Panel (In Patch Mode)
1. 6 individual footswitches with independent corresponding LEDs that tell you the
current selected footswitch once pressed.
2. 'Footswitch 5' controls 'Bank down' and 'Footswitch 6' selects 'Bank up'.
3. Stage-visible front facing LED display. Once the unit is powered on the LED
display will illuminate.

Rear Panel

4. 2 MIDI In/ Out sockets allow you to connect MIDI hardware using standard 5 pin
DIN cables.
5. Two individual expression pedal inputs allow you to connect up to two pedals
at a time. These can be programmed using the USB control software.
P OW E R D C 9 V U S B M O D E
C U S TO M
1
6. MODE select switches between 'PATCH' and 'CUSTOM' modes.
Switching the MODE switch to the Left/ 'PATCH' will allow you to send Program
Change (PC) messages to any connected MIDI device(s) via MIDI cable or USB.
 Program range (0-127/1 - 128) can be selected via the USB control software
 Switches 1 - 4: Send corresponding Program Change message, in banks of 4
 Switch 5: Bank down
 Switch 6: Bank up
8
M I D I C U S T O M U S B M I D I C O N T R O L
O U T I N
L I V E L O G I C
3 4 5
B A N K B A N K
E X P M I D I C U S T O M U S B M I D I C O N T R O L
PATC H 2 1 O U T I N
L I V E L O G I C
2 3 4 5
B A N K
Switching to the Right/ 'CUSTOM' allows you to use the Blackstar Live Logic Midi
control software via USB to customise the MIDI messages being sent via MID cable
and USB. Map any of the following message types to the six footswitches:
 Program Change
 Control Change
 Note
 Clock
6
 Note
7 & 8. The Live Logic Footcontroller can be powered by either USB from your PC/
Mac, a suitable 9V battery or Blackstar's compact PSU-500 (sold separately) which
operates from 100-240V AC and comes with 4 different plug fittings, making it
usable in many countries around the world.
9. Pushing the power button 'in' will turn the unit on, illuminating the front LED panel.
Pressing the button again to the 'out' position will shut the Live Logic Footcontroller
off immediately.
Examples of correct setup with specific products
Blackstar Silverline
 Live Logic MIDI output  Silverline MIDI input
 Patch mode - changing patch on your Silverline (Set patch mode display to offset)
 Custom mode  Download the Silverline Template from
https://www.blackstaramps.com/uk/ranges/live-logic/usb-midi-controller for an
example of MIDI Mapping.
P OW E R D C 9 V
6
B A N K
1
U S B M O D E E X P M I D I C U S T O M U S B M I D I C O N T R O L
C U S TO M PATC H 2 1 O U T I N
L I V E L O G I C
2 3 4 5 6
B A N K B A N K
9