Tabla de contenido
Publicidad
power supply. Do not pull on the cord to disconnect the plug from the wall socket.
5. If the power cord is damaged or defective, it must be replaced by an authorized service
center to avoid a hazard.
6. When you have finished ironing or when you are leaving iron unattended:
-turn the steam control knob(3) to position"0", and the temperature control dial(6) to
"OFF"
-stand the iron upright,
-disconnect the iron from the wall outlet.
7. The appliance is not intended for use by persons (including children) with reduced
physical, sensory or mental capabilities, or lack of experience and knowledge, unless
they have been given supervision or instruction concerning use of the appliance by a
person responsible for their safety.
Children should be supervised to ensure that they do not play with the appliance.
8. Do not immerse the iron or the cord into water or any other liquid.
9. Do not touch hot metal parts, hot water or steam. These parts become hot and may
cause burns. Take care if you turn the iron upside downs :there may be not hot water in
the tank.
10. The plug and cord should not be allowed to touch the hot sole plate. Let the iron cool
down completely before taking it away. Roll the power cord around the iron for storage.
11. Disconnect the iron from the wall outlet while filling with water or when emptying the
water after use.
12. To avoid an overloaded circuit, do not operate another high voltage appliance in the
same electric circuit.
13. Never use an extension power cord set that is not approved by a competent authority.
The cord should be rated for 10A (Europe) or 15A (America), cords rated for less
amperage may overheat. The cord should be arranged in a way that is cannot be
pulled or tripped over.
14. When placing the iron on its stand, ensure that the surface on which the stand is
placed is stable.
15. The iron is not to be used if it has been dropped, if there are visible signs of damage or
if it is leaking.
16. The iron must be used and rested on a stable surface.
17. The iron is for household use only.
SAVE THE INSTRUCTION MANUAL FOR FUTURE REFERRNCE
Notes
:
Some parts of the iron have been slightly greased and as a result, the iron may
smoke slightly when switched on for the first time. It will not happen again after a few
uses.
Before using for the first time remove any protective films or stickers from the sole
plate and the cabinet. Clean the sole place with a soft cloth.
When using the iron for the first time, test it on an old piece of fabric to ensure that the
sole plate and water tank are completely clean.
Publicidad
Tabla de contenido
