METRICA 120zoom Manual Del Usuario página 26

2. Align the cross displayed on the object to be measured, and
then perform the distance measurement.
3. To exit the camera mode, press briefly
button once to clear the measurement result. By pressing this
button twice, you leave the camera mode.
4. If you are already in the mode area, volume, Pythagoras and
want to use the camera function to aim the objective, press
Press to take the first measurement, exit the camera
mode with and the measurement will remain on the scre-
en. Return to the camera mode with
cond measurement with
sults of the selected function will be displayed on the screen.
5. For continuous measurement with camera mode activated:
switch on camera mode, then press and hold
of the measurement is displayed on the screen.
Important: In camera zoom mode with the buttons
activate the 2x and 4x-ZOOM
Zoom
26
. Press the
and carry out the se-
. To finish, press and the re-
The result
and
X-axis tilt
Y-axis tilt
Target
Measurement
DELAYED MEASUREMENT
Press long , the delay time will be displayed on the screen
in seconds. Short press
maximum value, 3s is the minimum value.
Then briefly press
ction.
.
STAKE OUT
Value a
Value b
Fig. 7
The user can use the tracking function to find the position corre-
sponding to the defined distance
1. Press and hold
2. Setting the value:
- Press or to set the value "a", press
- Press or to set the value "b", press
3. Arrows: : go back, : go forward, : in position
4. Short press to stop this function.
or to set the time. 60s is the
to start the delayed measurement fun-
Tracking
Value a
Value b
Arrow
Difference
Fig.8
, the display shows as in Fig. 7
to confirm
to confirm