Storage; Removal From Storage - Wilks USA TX850 Manual De Instrucciones

TX850

Storage

If the washer is not to be used or is to be stored for more than one month the following storage
procedure should be carried out:
01. Drain all the fuel from the fuel tank and the carburettor. Ensure that all fuel has been removed.
02. Remove the spark plug and pour approximately one table spoon full of clean engine oil into
the spark plug hole.
03. With the ignition turned OFF, gently pull on the recoil starter handle several times.
04. Re-fit the spark plug and continue to pull the recoil starter handle until the piston is on the
compression stroke (when resistance is felt) then stop pulling.
05. Store the pressure washer in a dry well ventilated place under a cover to prevent any dust or
debris from accumulating on the pressure washer.
If the pressure washer is not being used for more than three months or if there is any danger of ice or
frost where the unit is stored, especially during the winter months, certain precautions must be taken to
ensure no damage occurs to your washer or gun. Follow the previous steps for storage but also ensure
there is no water left inside the unit. The pump may require insulated protection from freezing conditions.
The gun must be drained of fluids to avoid water expansion as this will damage your gun.

Removal from storage

No fuel should have been left in the unit. However if any fuel is present, ensure this is removed from the
tank and carburettor before refuelling with fresh fuel. Check the deposit cup and empty if necessary.
Note: old fuel will not combust correctly and could damage your engine.
English
© Wilks-USA 13