4
Setting up the Web camera
Installing the drivers
Note: Install the driver first, then connect the Web camera to a USB port on your computer.
Windows Environment
To install the Windows driver:
1 Insert the Dynex Installation CD into the CD drive of your computer. The installation
program automatically starts.
If the installation program does not start automatically, click Start, Run, type
D:\Setup.exe (where "D" is your CD drive), then press Enter. The Install screen
opens.
2 Click Driver, then follow the on-screen instructions.
3 Install "DirectX" from the CD, if necessary.
Note: To remove the Windows driver, click Start, All Programs, Dynex WebCam, then click
Mac Environment
To install the Mac driver:
1 Insert the Dynex Installation CD into the CD-ROM drive of your computer, then double
click on the CD-ROM drive.
2 Click the Dynex Driver OSX 1.0 file folder.
3 Click Dynex Driver Install, then follow the on-screen instructions.
Note:
Uninstall. Follow the on-screen instructions to remove the driver.
This Dynex Web camera is not compatible with iChat, because iChat only supports Apple's Web
cameras or IEEE 1394 Web cameras.
Setting up the Web camera