Operating Instructions - simatherm HPS Manual De Instrucciones

3

Operating instructions

• Make sure the voltage marked on the hot plate corresponds with the
one available from the main supply.
• Connect the hot plate to the power supply. Due to the many types of
mains plugs, no mains plug is supplied with the HPS/HPL. A quali-
fied electrician must install a suitable mains plug. The correct supply
voltage is shown in section 2.1.
• Set the thermostat to the required temperature. Recommended tempe-
rature for bearings is 110°C (230°F).
• Turn the unit on by pressing the ON/OFF switch. Main pilot lamp will
light up (green)
• The second pilot lamp (red) is lit while the hot plate is being heated
but switches off as soon as the selected temperature has been rea-
ched.
• The temperature of the hot plate will remain within 10°C (18°F) of the
selected value.
© simatec ag Hot Plate Small HPS / Hot Plate Large HPL 13