Setting The Volume; Monitor Button; Push-To-Talk Time-Out Timer; Talking And Listening - Monacor TLKR T92 H2O El Manual Del Propietario

2. The display screen then shows the current channel, code
and all features that are enabled.

Setting the Volume

From Standby Mode, press on either
current value. Press or
setting.
1. Press to increase the speaker volume.
2. Press to decrease the speaker volume.
Do not hold the radio close to your ear. If the volume is set to an
uncomfortable level, it could hurt your ear.
Adjust '0' to mute the speaker.

TALKING AND LISTENING

All radios in your group must be set to the same channel and
Interference Eliminator Code in order to communicate.
1. Hold your radio 5–8 cm from your mouth.
2. Press and hold the PTT button while speaking. The Transmit
icon appears on the display.
3. Release the PTT button. You can now receive incoming
calls. When you do, the Receive
display.
For maximum clarity, hold the radio 2 to 3 inches away and
avoid covering the microphone while talking.
Talk Range
Your radio is designed to maximize performance and improve
transmission range. Do not use the radios closer than 5 feet
apart.
or to show the
again to adjust the volume
icon appears on the

Monitor Button

Pressing and holding Scan/Monitor button 3 seconds
allows you to listen to the volume level of the radio when you
are not receiving. This allows you to adjust the volume, if
necessary. You can also press
check the activity on your current channel before you talk.

Push-to-Talk Time-out Timer

To prevent accidental transmissions and save battery life, the
radio emits a continuous warning tone and stops transmitting if
you press the PTT button for 60 seconds continuously.
Scan/Monitor button to
5