Cautions; Connecting The Hob To The Mains Power Supply - MiLECTRIC ECM-3F Manual De Usuario

A B C
screw bracket Screw hole
Adjust the bracket position to suit for different work surface's thickness.
Under any circumstances, the brackets cannot touch with the inner surfaces of the worktop after
installation (see picture)

8.3 Cautions

1. The ceramic cooker hob must be installed by qualified personnel or technicians. We have professionals
at your service. Please never conduct the operation by yourself.
2. The ceramic cooker hob shall not be mounted to cooling equipment, dishwashers and rotary dryers.
3. The ceramic cooker hob shall be installed such that better heat radiation can be ensured to enhance its
reliability.
4. The wall and induced heating zone above the work surface shall withstand heat.
5. To avoid any damage, the sandwich layer and adhesive must be resistant to heat.
6. A steam cleaner is not to be used.

8.4 Connecting the hob to the mains power supply

The power supply should be connected in compliance with the relevant standard, or a single-pole circuit
breaker. The method of connection is shown below.
D
base
.
20