Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
English
The Ref. 100276 is a simple polishing lathe
especially designed to polish and grind small items
in the field of dental mechanics.
INSTALLATION
1. Carefuly unpack the unit. Check that it has not
sustained damage during shipment.
It is supplied with the following accessories:
- 1 right-hand thread brush holder.
- 1 left-hand thread brush holder.
- 1 cloth wheel Ø100.
- 1 Allen wrench.
2. Place the unit on a flat and firm surface remote
from any source of heat or vibration.
3. Connect the unit to a 230 V, 50/60 Hz outlet with
earth.
FITTING THE BRUSH TO THE BRUSH HOLDER
Insert the brush into the brush-holder, ensuring
1.
that the brush-holder shaft is perpendicular to
the plane of the brush.
Screw the brush onto the brush-holder as tightly
2.
as possible by hand.
Visually check that the brush-holder shaft is
3.
perpendicular to the plane of the brush by
spinning the assembly in your hand.
Start up the unit: the spin of the motor will reveal
4.
whether the wheel or brush is off line. If there is
more than 2 mm of slip, dismount and re-fit the
wheel-holder or brush-holder.
Remember that the friction torque produced
5.
during work after a brush is fitted to the brush-
holder will keep it tight. This effect can be
favoured by a suitable workpiece attack angle.
Note. Max. disc diameter: 125 mm.
EN
CONDITIONS OF USE
For best results use the unit as follows:
▪ Connect the unit to a 230 V, 50/60 Hz power
source.
▪ Turn on the main switch (G).
▪ Select the desired spin speed (3000-7000 rpm)
turning selector (B).
▪ Before polishing or grinding a workpiece, check
the motor spin direction, as the initial workpiece
attack angle depends on this. Incorrect attack
angles can be extremely dangerous.
▪ The
following
recommended for polishing or grinding:
- safety goggles;
- safety gauntlets;
- face-mask;
- proper exhausters;
- a
protective
characteristics
TALLERES MESTRAITUA, S.L. recommends
Ref. 080200 / 080210 screens, which are
especially designed for use with the polisher.
- Proper clothes. No baggy clothes, ties,
necklaces, rings, bracelets or elements that
could be hooked by the machine.
- Be careful with long hair.
- No objects similar to ropes or chains that
Could be hooked by the machine.
▪ After using the unit, clean the inside of the
protective screen.
MAINTENANCE AND CLEANING
To ensure a long, trouble-free useful life for your
unit, proceed as follows:
▪ To clean the motor and base used a cloth.
Never
use
inflammable liquids.
▪ Never immerse the unit in any liquid.
▪ If you notice unusual noises or vibrations, send
the unit to your technical assistance service.
▪ This unit is designed to work correctly on the
four rubber legs (C).
▪ The motor has two brushes that will wear out
with the use. To replace them, remove the plugs
(D) using a screwdriver.
protective
equipment
screen
suited
and
shape
of
alcohol,
solvents
is
to
the
the
unit.
or
other
Publicidad
Tabla de contenido
