REV FR-74 Manual Del Usuario página 16

MODE - selector switch u sing the "entry warning device"
Slide the MODE - selector switch (2) to the position " ".
The transmitter now needs approx. 20 sec. until the infrared
sensor is activated. If movement is registered in the area being
monitored, the indicator lamp (5) briefly lights up and the
transmitter lets out a "DING-DONG" sound.
(6)
With the automatic controller , you can regulate the signal
volume on the rear off the device, but you cannot to switch this
off completely.
NOTE:
The signal repeats when further movement is detected.
MODE - selector switch using the "alarm device"
Slide the tone selector switch (2) to the " " position. The
transmitter now needs approx. 20 sec. until the infrared sensor
is activated. Exit the monitored area within this time period.
The alarm device is now switched to active. If movement is
registered within the monitored area, the indicator lamp (5)
lights up briefly and an alarm tone lasting for approx. 30 sec.
immediately sounds. The volume button has in position
no function.
NOTE:
After the alarm tone ceases to sound, the sensor is still active
and any new movement will reactive the alarm.
Switching off the alarm tone
(2)
Return the MODE - selector switch to the " " position.
In this position no signal is hearable at the transmitter and the
receiver.
(3)
Loudspeaker switch
If the signal-tone is not audible on the transmitter, set the
(3)
loudspeaker switch to " " . The gong and alarm tone
are now switched off.
15