Aligning The Stylus - MH RWT35.50 Instrucciones De Operación

Radio-wave Tool Setter RWT35.50

Aligning the Stylus

Dial gauge
#3079
Steps:
Loosen the clamping screws and turn the adjustment bolts until they reach their limit in the upper position.
Tighten the clamping screws so until the adjustment bolts can just be turned with moderate-force.
Blow the adjustment bolts and the V-Slots clean.
Place the Tool Setter in the V-Slots.
Check the parallelism of the stylus in the X Axis using an dial gauge.
Adjust the Tool Setter in the Y Axis to < 5µm by turning the adjustment bolts.
Tighten (2x) the adjustment bolts.
Using the third adjustment bolt, adjust the tool setter around the X-Axis to < 5µm
Tighten the third adjustment bolt
Take the Tool Setter out of the machine and securely tighten all 3 clamping screws
by hand (ca.10Nm).
Blow off the adjustment bolts and the V-Slots.
Put the tool setter back in the V-Slots and verify the alignment.
Calibrate the Tool Setter!
Y-Axis
Adjustment bolts
AF3mm #4277
8
Clamping screws
AF3mm #5114
Hexagon Key
AF3mm #1780
X-Axis