Re-Assigning Device Keys - COX M7810A Guía Del Usario

RE-ASSIGNING DEVICE KEYS

The Cox Universal Remote Control can be set up to
control a VCR or second TV, or any combination of up to
four home entertainment devices. For example, to have
the unit control a TV, a Cable Converter, a DVD player
and a VCR, you will need to re-assign the unused AUX
key to operate the VCR as follows:
1. On the remote control, press AUX once.
Then press and hold SETUP until the AUX key
blinks twice, then release SETUP.
2. Enter 9 - 9 - 2. The AUX key will blink twice.
3. Press press AUX once. The AUX key will blink
twice.
4. The AUX key is now ready to be programmed
for your VCR. See Programming Device
Control on page 9.
To re-assign other device keys, repeat steps 1–4 and
substitute the key sequence using the following chart:
To Re-Assign
TV as 2nd DVD key
TV as 2nd Auxiliary key
TV as 2nd Cable key
TV back to TV
DVD as 2nd TV key
DVD as 2nd Auxiliary key SETUP - 9 - 9 - 2 - AUX - DVD
DVD as 2nd Cable key
DVD back to DVD
AUX as 2nd TV key
AUX as 2nd VCR key
AUX as 2nd Cable key
AUX back to AUX
Upon completion of a re-assignment, the selected mode
key will blink twice to confirm your selection. Then
you'll need to program device control (see Programming
Device Control on page 9).
Perform Key Sequence
SETUP - 9 - 9 - 2 - DVD - TV
SETUP - 9 - 9 - 2 - AUX - TV
SETUP - 9 - 9 - 2 - CABLE - TV
SETUP - 9 - 9 - 2 - TV - TV
SETUP - 9 - 9 - 2 - TV - DVD
SETUP - 9 - 9 - 2 - CABLE - DVD
SETUP - 9 - 9 - 2 - DVD - DVD
SETUP - 9 - 9 - 2 - TV - AUX
SETUP - 9 - 9 - 2 - DVD - AUX
SETUP - 9 - 9 - 2 - CABLE - AUX
SETUP - 9 - 9 - 2 - AUX - AUX
17