Troubleshooting - COX M7810A Guía Del Usario

2. Enter 9 - 9 - 3. The AUX key will blink twice.
3. Press AUX once. It will blink twice.
4. Now, whenever you press VOL+, VOL–, or
MUTE, the volume will be controlled by your
auxiliary device.

TROUBLESHOOTING

PROBLEM: Mode key does not blink when you press a key.
SOLUTION: Replace the batteries with two (2) new AA
PROBLEM: Mode key blinks when you press a key, but
SOLUTION: Make sure you are aiming the remote control
PROBLEM: The remote control does not control home
SOLUTION: Try all listed codes for the device brand being
PROBLEM: TV/VCR combo does not respond properly.
SOLUTION: Use the VCR codes for your brand. Some
PROBLEM: No volume on a second TV.
SOLUTION: Follow instructions in Changing Volume Lock
PROBLEM:
SOLUTION: Due to RCA design (1983–1987), only the
PROBLEM: Changing channels does not work properly.
SOLUTION: If original remote control required pressing
PROBLEM: Tried "Search For Your Code" and still could
alkaline batteries (see page 8).
home entertainment device does not respond.
at your home entertainment device and that
you are within 15 feet of the device you are
trying to control.
entertainment devices or commands are not
performing properly.
set up. Make sure all devices can be operated
with an infrared remote control.
combo units may require both a TV code and
a VCR code for full operation (see page 10).
(see previous page).
CH+ CH –
, , and
RCA TV.
original remote control will operate these
functions.
ENTER
to change channels, press
the remote control after entering a channel
number.
LAST
do not work for your
19
ENTER
on