Omega Lift Equipment 60120 Manual De Instrucciones De Funcionamiento página 5

Assembly
Model 60200: (Refer to Figure 4)
Note: Do not tighten any bolts unless told to do so.
1. Attach base legs (1) to upright channels (2) with bolts, lock washers and nuts (3). Hand tighten only.
2. Attach lower cross member (4) to upright channels (2) with bolts, lock washers and nuts (3).
3. Attach support links (5) to the base (1) and upright channels (2) with bolts, lock washers and nuts (3).
4. Carefully slide bed frame (6) down to lowest possible position between the upright channels (2).
5. Attach the screw hooks (7) to the jack bracket (8) with nuts (9). Leave nut untighten to provide easier spring
attachment later.
6. Slide the jack bracket (8) down between upright channels (2) onto the bed frame (6).
7. Attach upper cross members (10) to upright channels (2) with bolts, flat washers, lock washers and nuts (11).
8. Attach head plate (12) to upper cross members (10) with bolts, lock washers and square washers (13).
9. Attach two bolts, lock washers and nuts (14) thru the upper cross member (10). Then attach one end of the springs
(15) to the bolts (14) and the other end to the screw hooks (7) on the jack bracket.
10. Carefully place the bottle jack (16) between the head plate (12) and jack bracket (8). Tighten the nuts (9) that
hold screw hooks (7) to prevent jack from inadvertently falling out.
11.Tighten all applicable nuts and bolt assemblies.
12. Carefully bring the bed frame (6) up and secure it
with pins (19).
13. Place the Arbor Plates (17) on Bed Frame (6).
14.The press is now ready to use. Don't forget to insert the handle (18) into handle sleeve of bottle jack
NOTICE: Before disassembly, carefully slide bed to its fully lowered position.
Size of Hardware Kits
3 bolt M10x25
lock washer M10
nut M10
9 nut M8
11 bolt M16x150
flat washer M16
lock washer M16
nut M16
13 bolt M10x25
lock washer M10
square washer M10
14 bolt M10x130
lock washer M10
nut M10
18
11
Qty
12
19
12
12
2
4
8
4
4
4
4
4
2
2
2
Figure 4 - Assembly Illustration for model 60200
14
13
16
4
3
3
5
10
12
15
7
8
17
9
6
2
1
5