Control Box Buttons; Button Functions; Start / Stop Cleaning And Select Cleaning Time - Zodiac Pool Systems EN27 Serie Manual Del Propietário

8
4. Place all of the floating cable in the water
to allow free movement in your pool from
the central point. Spread out the floating
cable ensuring there are no kinks or coils
in the cable (Figure 5).
cleaner
cleaner
Figure 5. Pool Entry Point for Optimal Patterning

Control Box Buttons

The control box can be used to initiate basic
cleaning features and to connect the device to
home Wi-Fi (connected models only).
For more information on connecting your cleaner to Wi-Fi
(connected models),see Section 5, Installing iAquaLink

Button Functions

Start/Stop cleaning
Select cleaning mode*
Remove cleaner from the pool*
Initiate connection and set up iAquaLink
control*
*not available on all models
Not
Recommended
caddy /
control unit
Recommended
entry point
WARNING: Do not use
an extension cord
®
.
®
Robotic Pool Cleaner
Start / Stop Cleaning and Select
Cleaning Mode
The factory default cleaning mode is set to Floor,
Wall, Waterline.
Use to change cleaning surface setting.*
Toggle between modes:
Floor Only (1h 30 min)
Floor, Wall, Waterline (2 hours 30 minutes)
With the cleaner submerged in the water,
press to begin operation.
Press again to interrupt and cancel an in-progress
cleaning cycle.
*not available on all models
|
Owner's Manual